Fashion Jewelry

Kam Zinsser – Silver Cross Necklace

Supplies:

Silver Cross
1 leap at ring
Flower beads
Colored Tabloid    
2 crimp beads    
Blue beads
Puny Paper Flower
1 lobster catch
green beads
Clear Crystals
Crystal beads    
.015 wire
Silver beads

Tools:                

E 6000 adhesive        
EnviroTex Lite Pour-On    

To offset the silver cross:

Tear colored paper into poor pieces. Arrange them on the cross to make your own lay out. I used mainly the purple and country-like paper. Once you have a design that you like, cement your paper to the cross. Glue the small brown certificate flower to the center of the cross. Glue a indisputable crystal to the center of the flower. Mix up enough EnviroTex Lite Let out-On to cover the design. Please follow the directions for mixing this discovery that are on the box. Pour your solution over the design on the cross. Let this dry for a few days. Imply sure not to pour too much so it won’t go over the sides.

To induce the necklace:

Measure out about 21″ of wire to originate an 18″ necklace. Put one crimp bead on one end of the wire and the gambol ring. Thread the wire back through the crimp bead and nick closed with your tool. Start threading your beads on the wire. Start with a draft of a silver bead, green bead, and then a morose bead. Continue with this pattern until you have four of each on the wire. Start the figure again but then thread a flower bead on the wire between two silver beads. Start the same figure again but thread a clear crystal bead between two silver beads. When you have completed these patterns, subject another flower bead on the wire, put the cross on, and then story-line another flower bead on. You will then mirror the other side of the wire...

Read more...